Drilling Machine (TD45A)

Spindle taper: MT-4
Spindle travel: 130mm
Quill diameter: 115mm
Drilling capacity 45mm
Tapping capacity (steel) M24
Tapping capacity (cast iron) M32
Spindle taper MT4 Spindle drawbar thread M14
Spindle travel 130mm
Spindle speed 90 / 1600rpm
6 Spindle auto-feeds 0.06, 0.09, 0.12, 0.15, 0.18, 0.30MM
Distance from spindle to coloum 290mm
Distance from spindle to worktable 725mm
Distance from spindle to base 1125mm
Coloum diameter 115mm Coloum thickness 16mm
Headstock travel 250mm
Headstock swivel (horizontal) 360 degrees
Headstock tilt 90 degrees
Work table up / down 600mm
Work table size 380x460mm
Work table work area 300x380mm
Work table T slot 16mm
Work table swivel 360 degrees
Work tabel tilt ± 45 degrees
base size 730x500mm
base work area 415x415mm
base T slot 16mm
Spindle motor 1.5kw /240V single phase/ 3 phase also available
Coolant motor 40W
Net weight 440kgs
Gross weight 500kgs